Zigzag Dribbling is an Advanced dribbling drill that uses cones. Its goal is to build fast changes of direction while keeping the ball under control. You set 6 cones in a wide zigzag, dribble quickly to each one, cut sharply and push toward the next, speeding up after every cut. These zigzag dribbling tips focus on the part most players skip: the burst after the cut.
What this drill trains
Lots of dribbling drills ask you to go around cones. This one asks you to attack them. Each cone is like a defender you run at, then leave behind with a quick change of direction. Doing that six times in a row, at pace, trains your feet to cut cleanly even when your legs are working hard.
It’s a step up from the single turn in V-Dribbling, where you turn at one point and come back. Here the cuts come one after another.
Building the zigzag
Place 6 cones about 3 yards apart, alternating left and right so they form a wide zigzag. Wide matters: each cut should be a real change of direction, not a small drift. Leave space at the end of the line so you can slow down and jog back. A flat lawn or an empty part of a park field works well, since you’ll be moving fast and planting hard on each cut. Clear away sticks, stones and toys before you start.
Keys to a sharp cut
- Arrive under control. Fast doesn’t help if the ball is a yard ahead of you at the cone.
- Cut with the inside or outside of the foot. The inside pulls the ball across you; the outside pushes it away from the cone.
- Plant and push off. Lower your hips as you cut so your legs can drive you out.
- Accelerate out. The drill asks you to speed up after every cut. Two or three quick steps are enough.
Typical slip-ups
- Rounding off each cone in a gentle curve instead of cutting.
- Slowing down after the cut instead of speeding up.
- Using the same cut on every run, even though the drill asks for variety.
- Touching the ball too far ahead between cones.
Scaling it back
Walk the zigzag with the ball once, then jog it. Use only the inside of the foot until the cuts feel natural. If the ball keeps escaping, take smaller touches between cones. It’s fine to treat speed as something you add later. Clean cuts at a jog are better practice than messy ones at a sprint.
Pushing it further
- Try a different cut on each run, as the drill suggests: inside, outside, then a mix.
- Use only your weaker foot for a full run.
- Time each run and try to beat it, then look at the Speed Dribbling Challenge for a full plan.
- For tighter, quicker weaving, try Slalom Dribbling.
A sample session
- Set the 6 cones about 3 yards apart in a wide zigzag.
- Do 2 runs with inside-of-the-foot cuts, focusing on control.
- Do 2 runs with outside-of-the-foot cuts.
- Finish with 2 runs mixing cuts, speeding up after each one.
- Jog back between runs to recover.
Related reading
For a gentler turning drill, see Practice Notes: V-Dribbling and Practice Notes: Slalom Dribbling. The Change of Direction Challenge gives you a ready-made plan for this skill, and our dribbling drills page has the rest.